Table of Contents
Advertisement
Valve Replacement
Removing Valve
1. Shut off the gas and electrical supply.
2. Remove the safety screen.
3. Remove the glass door.
4. Remove the logs and glass.
5. Remove the log grate assembly by removing 2
screws and sliding tray forward to remove.
Diagram 1: Remove left and right screws.
6. Remove lower (brick or enamel) panel.
7. Remove 3 screws securing the bruner and then
slide the burner assembly to the right to release
it from the orifice, then lift it out
Diagram 2
8. Remove 2 screws securing the fan access
(Diagram 3).
Diagram 3
9. Disconnect the inlet gas line.
10. Disconnect the two switch wires from the valve,
as shown below.
Diagram 4
Switch wires
11. Disconnect spark electrode from DC sparker
box, as shown below.
Electrode wire
Diagram 5
12. Remove the 12 screws securing the valve tray
assembly in place (Diagram 6) and then lift out
entire assembly.
Diagram 6
13. Remove Philips head screws securing DC
sparker box, as shown below.
Philips head screw
Diagram 7
maintenance
Replacing Thermocouple
1. Follow steps 1-13 for replacing valve.
2. Disconnect thermocouple at gas valve.
Thermocouple
3. Disconnect thermocouple at pilot assembly end.
4. Replace thermocouple.
5. Reverse steps 1-13.
G600C Gas Fireplace | 91
Grandview
®
Advertisement
Table of Contents
