Epilog Laser FiberMark Fusion 13000 Owner's Manual page 144

S Sectio on 11:
In add dition to the
on the e left side of
regula ar cleaning.
The p photos below
the ma achine to cle
Clean ning and
The b bearing syste
use. U Use a soft c
clean each of the
cotton n swab is pe
rail. About once
lubric ant Syringe
groov ves. Each rail
The g rease should
Engra aving M
focus lens a and the mirro
f the X-beam m. This mirro
It can be acc cessed with
w shows how w to clean th
ean both the top and bott
d Lubri icating
em in the las ser should b
cloth or cott ton swab wi
e bearing tra acks which
erfect for cle eaning out th
e every three e months, yo
from your a accessory kit
l has two gro ooves – one
d go down in nside the gro
13 30
Machi ne Cle
or directly a above it, ther
or is very we ell protected
a cotton swa ab if it does
he focus lens s. Remove th
tom of this l lens.
the Bea aring R
be cleaned a about once a
ith some alc cohol or sim
the optics ( (mirror and
he inside of the grooved
ou should lu ubricate the
t, apply a thi in bead of gr
on the top a and one on th
ooves on eac ch side of the
eaning g
re is a mirro or located
d and should not need
need cleanin ng.
he lens carra aige from
Rails
a week depe ending on
milar mild so olvent to
lens) run a along. A
d tracks of th he x-axis
bearings. U Using the
rease into the e bearing
he bottom o f the rail.
e bearing.