Epilog Laser FiberMark Fusion 13000 Owner's Manual page 81

Sectio on 6: U
requir red when usi
auto f focus to the t
Use a pair of calip
enter t this value in
NING: If y
WARN
cleara ance between
table b before you i
w keys on th
Arrow
use th he Joystick to
Note: Please be
crash bar and ai
situat tion also.
Crash h Bar
Using t the Ep
ing the vecto or grid. If a t
top of the ve ector grid, no
pers for an a accurate mea
n the "Thickn ness" box in
you are usin ng Auto Fo
n the lens ca arriage and y
nsert your m material and
e keypad to illuminate t
o lower the t table enough
careful whe en auto focu
ir assist tub be must cle
67 6
pilog D Dashbo
thickness is not specifie
ot to the top of your mate
asurement of f your mater
the driver.
ocus and you u know ther
your materia al, you will n
start the job b. To lower
the light nex xt to the wor
h to accomm modate your p
using on irr regularly sh
ear all edge es of the wo
oard
ed the system m will
erial.
rial thicknes ss and
re is not en nough
need to lowe er the
the table, us se the
d "Focus". Then
part.
aped items. The
ork piece in n this