Section 8: Using The Front Control Panel - Epilog Laser FiberMark Fusion 13000 Owner's Manual

Section 8: Using the Front Control Panel

STOP
Pressing the STOP key will stop the lens carriage and the laser beam will be shut off.
If the STOP key is pressed during raster engraving mode the lens carriage will stop
on either the far left or far right of the engraving line that is in process. If the STOP
key is pressed while in vector cutting mode, the lens carriage will stop at the end of a
line segment or at the next line node location. Once the lens carriage has stopped,
you can open the door to examine the engraving. By closing the door and pressing
the GO key, the engraving / cutting job will commence where it left off. If the item
being engraved is not moved the engraving / cutting registration will not be affected.
Note: Opening the door on the laser during engraving or cutting will stop the laser
from firing; however the lens carriage will continue to move. It is important to STOP
the job before you open the door to ensure the engraving / cutting is completed.
If you press the STOP key while in vector mode it may take some time for the system
to actually stop. The system needs to get to the next node in a vector before it can
stop.
RESET
Pressing the RESET key will move the carriage back to its Home position. Press the
RESET button after you have pressed the STOP button, or after you have moved the
carriage when in the Jog position.
RESET does not erase the job from the laser systems memory; rather it will stop the
engraving job in process and send the carriage back to the home position.
108