Epilog Laser Legend 6000 Owner's Manual page 92

Owner's Manual for EPILOG Legend Model 6000
December, 2000
laser will cut entirely through the material, separating the part from the background. For marking
(engraving), the laser is swept across the work from left to right, and the laser is turned on and off at the
correct points to produce the first line of the image. Then the carriage advances one line and the process is
repeated, eventually assembling a full image.
Federal Communications Commission (FCC) Notice
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy; and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at his own expense.
88 Section 17 – Specifications