Optional Equipment; Double Head - Epilog Laser Legend 6000 Owner's Manual

Table of Contents

Owner's Manual for EPILOG Legend Model 6000

Optional equipment can be purchased with the Legend laser systems. These items are in addition to the standard items

included with a Legend purchase. These items can be added to your Legend at a latter time after purchase if requested

and purchased. The current optional equipment described following includes the "Double Head Attachment", "Rotary",

"Air Assist", "Auto Focus" and "Additional Optical Lens".

INSTALLATION

Locate the components for the Double head option.

•

Connecting strut

•

Optical Plate

1) With the machine off, open the door and slowly pull the "I" beam assembly to the front of the

machine to where it is a comfortable reach.

2) Put the optical plate up against the second bearing block and tighten the holding screw.

3) Space the primary and secondary heads about 16 inches apart, and place the connecting strut in

between the heads. Align the holes in the end of the strut with the holes on the carriages, and insert

and tighten the thumbscrews. Please see the drawing on the next page.

ARTWORK LAYOUT

Lay out your work on a maximum page size of 16" wide and 20" tall. If you try to go beyond 16" width the

machine will give an error and stop. Remember, the machine will take care of the duplication automatically.

Prepare your artwork as though you were making only a single piece.

If you ordered the double head and are not using it, the area available as a single head is 30 x 20 inches.

Please keep the second head in a safe place so it stays clean. See the diagrams on the following page for

correct installation of the double head.

December, 2000

12)

OPTIONAL EQUIPMENT

Section 12 – Optional Equipment

Table of Contents