Epilog Laser Legend 6000 Owner's Manual page 30

Owner's Manual for EPILOG Legend Model 6000
December, 2000
engraving at the point where it stopped. As long as you did not disturb the work piece, it will continue
engraving without loss of registration.
GO
This key serves two purposes. 1) Use this key to continue a job that has been stopped. If the machine has
been stopped mid-job it will resume where it left off. 2) Pressing this key immediately before a job is sent to
be printed puts the Legend into "Idle" mode and will allow the sent job to start immediately without accessing
the "Jobs" menu.
RESET
This key is used to reset the carriage to home position. RESET does not erase a design/job from memory.
Resetting the Legend will send the carriage back to home position and allow you to repeat the same
design/job or begin a new one. The "STOP" key should always be used to stop the job before pressing the
"RESET" key.
FOCUS
Pressing the FOCUS key and then turning the Jog/Shuttle knob raises or lowers the table to move your work
piece closer to, or further from, the fixed focus lens. A metal focus gauge is provided to determine the correct
distance from the work piece to the focus lens. The focus gauge is included in the accessory kit. The work
piece should be raised just to the point where the gauge touches your work piece. Remove the gauge when
you are done focusing. Press ENTER when you are done focusing. That will restore the control knob to the
menu.
ENTER AND ESCAPE (MENU CONTROLS)
The Legend has direct keys for the most commonly used functions. Others must be accessed through a menu.
Across the top of the Liquid Crystal Display (LCD) are the menu headings. Push the left and right arrow keys
and you will see the "active" heading scroll from left to right by means of highlighting. When the one you are
interested in is highlighted, press the ENTER key. That will cause the chosen menu heading to drop down,
much like the menus on a personal computer. Press the up and down arrow keys and the highlighted sub-
heading will scroll up and down. Again, when the one you want is highlighted press ENTER. You can either
select one from a list of choices, or enter a numeric quantity by turning the Jog/Shuttle knob (like speed or
power). You can back up one level in the menu by pressing the ESCAPE key. All the choices shown below
may not be available on your machine, as they involve optional features or equipment.
ARROWS
26 Section 6 – Using The Epilog Legend