Keyboard/Display; Beam - Epilog Laser Legend 6000 Owner's Manual

Owner's Manual for EPILOG Legend Model 6000
December, 2000

KEYBOARD/DISPLAY

The keyboard/display module for the Legend (part #LM5) is located on the cover of the Legend. To
remove/service this module, first turn the machine off and unplug the power cord from the machine or from
the wall. Open the large door. Remove the four nuts holding the metal cover over the keyboard/display.
Remove the cover. The keyboard is now loose, and should be supported with a free hand. On the right edge
of the keyboard there is a flat ribbon cable. Push the "ears" on the connector away from each other, and the
connector should back out far enough to be easily removed. The keyboard will now slide off the four
mounting posts. Installation is the reverse of removal.
X BEAM
The X beam module for the Legend (part #LM6-32) is located inside the Legend cabinet. To remove/service
this module, first, if you have not already done so, turn the machine off and unplug the power cord from the
machine or from the wall. Open the large door, and gently pull the beam forward until it is a comfortable
reach. Loosen the phillips head screw on the left of the beam, and the two captive screws on the right of the
beam shown in the drawing on the next page. The captive screws have a Phillips head, and are taller than
"normal" screws. Then disconnect the white flat cable from the right end of the beam. There is a small tab on
the top center of the connector that needs to be depressed to allow the cable to be removed. The clamp,
holding the cable down, needs to be removed as well. Installation of the new beam is the reverse of the
removal. Please be careful of the mirror mount on the right side of the beam. The mirror is prealigned, and
alignment will be lost if you bump it hard enough.
When installing the new beam, please start all three screws carefully prior to tightening any of them.
80 Section 15 – Servicing the Legend