Epilog Laser Legend 6000 Owner's Manual page 28

Owner's Manual for EPILOG Legend Model 6000
6. SHOULDERS: Use the slider bar to determine the size of the shoulders. A small number will give
steep shoulders, with a large number giving very broad shoulders. Shoulders of 25 or 30 are
recommended.
7. WIDENING: Use the adjuster to determine the width of the character as it is engraved. A low value
(1 or 2) will produce a narrow character. A high value (6 or 7) will produce wider, or bolder,
character. A value of 1 is recommended.
8. RATE AUTOMATIC: "RATE" varies the laser cutting frequency for the vector portion of the job.
Generally on rubber sheets, put an "X" in the rate automatic box.
9. AUTOFOCUS: Putting an "X" in the auto focus box enables the auto focus feature of the Legend if
you have the auto focus feature installed on your machine.
10. MIRROR: This feature is not currently available, do not place an "X" in this box. Mirror your
design in CorelDRAW prior to setting the properties in the print dialog window.
24
December, 2000
Section 5 – Using The Epilog Legend Print Drivers