Epilog Laser Legend 6000 Owner's Manual page 34

Owner's Manual for EPILOG Legend Model 6000
2. Run/Override: This selection allows you to override the computer controlled Speed, Power, and PPI
settings that were sent with the job from your computer. To use this selection:
a. Change the appropriate parameters (Speed/Power/PPI) in the "SETUP" menu.
b. Highlight the job that you want to run from the "JOBS" menu,
c. Press the "RUN/OVERRIDE" option. The job will run with the manual settings that you
have selected.
3. View: The LCD will display a facsimile of the job that you have selected. This feature does not
operate in vector mode if "smoothing" is enabled, or in rubber stamp mode.
4. Delete: Selecting "DELETE" will permanently remove that job from memory. You cannot delete a
job if it is currently running. You cannot retrieve a job that has been deleted.
You can load jobs at any time. All jobs will appear in the order that they were printed with the most current
job received at the top of the list.
For additional information on the Legend's memory, read Section 11, "Memory Configuration" contained in
this manual.
OPTIONS
The "OPTIONS" menu allows you to enable/disable all installed options. Highlight the "OPTIONS" menu,
then press "ENTER".
1. Auto Focus: Use the down arrow key to highlight "AUTO FOCUS" and press "ENTER". Turn the
"JOG/SHUTTLE KNOB" back and forth to select "Yes or No". Selecting "Yes" will enable the Auto
Focus to work when the "Auto Focus" command is selected in the print driver. If "Auto Focus" is not
selected in the print driver, the "Auto Focus" feature will not be enabled. Do not enable the Auto
Focus option unless your machine is actually equipped with the auto focus sensor. Erratic operation
will result.
2. Air Assist: Use the down arrow key to highlight "AIR ASSIST" and press "ENTER". This option
enables the Air Assist to be automatically turned On/Off during Raster engraving or Vector cutting
functions.
a. Raster: Turn the "JOG/SHUTTLE KNOB" to Select "YES" or "NO". Selecting "YES" will
turn on the Air Assist "ON" during raster mode and "NO" will turn it OFF. Next arrow down
to "VECTOR"
b. Vector: Turn the "JOG/SHUTTLE KNOB" to Select "YES" or "NO". Selecting "YES" will
turn on the Air Assist "ON" during vector mode and "NO" will turn it OFF. Then press
"ENTER".
The air assist option allows for deeper engraving and cutting than would otherwise be possible. The
compressed air assists in pushing away materials that might combust at the point of engraving. Never
leave your laser unattended while engraving or cutting. Some materials are extremely flammable
and burning cannot be extinguished even with the Air Assist at full flow. Generally, compressed air
at 20 PSI is adequate. Do not use gas other than air when using the Air Assist option. Never use
Oxygen with the Air Assist option.
3. Installed Options: This selection lists the installed options.
a. Rotary The "ROTARY" option allows you to mark or engrave cylindrical objects. This
menu item designates either installed by displaying "YES" or not installed by displaying
"NO".
30
December, 2000
Section 6 – Using The Epilog Legend