Using The Epilog Legend Print Drivers; Installing The Stamp Drivers; Using The Legend Engraver Print Driver - Epilog Laser Legend 6000 Owner's Manual

Owner's Manual for EPILOG Legend Model 6000
December, 2000

5) USING THE EPILOG LEGEND PRINT DRIVERS

The Epilog Legend print drivers allow you to control the system's functions from your computer. There are
two Legend print drivers found on the disk labeled Epilog in your accessories box. The first labeled the
"Legend Engraver" is your main driver for both engraving and cutting materials. The "Legend Stamp" driver
is used to engrave rubber stamp formats.

INSTALLING THE STAMP DRIVERS

The installation of both of these drivers is detailed in Section 1 under subheading Configuring Your Computer
– Print Driver Installation, of this manual. The two drivers are explained in further detail regarding their
properties in the following subsections.

USING THE LEGEND ENGRAVER PRINT DRIVER

The "Legend Engraver" print driver setup window is shown below.
1. RESOLUTION: Resolution determines how many cuts, or lines per inch, the machine will engrave.
Available resolutions range from 150 to 1200 DPI. 300 DPI is normally a minimum for production
Section 5 – Using The Epilog Legend Print Drivers 17