Loading Your Work; Operation - Epilog Laser Legend 6000 Owner's Manual

Owner's Manual for EPILOG Legend Model 6000

LOADING YOUR WORK

The home position of the engraving field is at the upper left corner of the table. Place your work piece in the
upper left corner, pressed firmly against the metal stops along the top and left edges.

OPERATION

Load a practice piece and set the focus. Close the door and press the GO key. Turn on the exhaust fan. Now
go into your drawing program (CorelDRAW, etc.) and set the page size to the dimensions of the practice
piece you have loaded. Then enter your name in half-inch text anywhere on the page. Once you have the
image ready to engrave, print to the machine through the Legend print driver using the standard print
command. Your drawing program should give you the opportunity to do a print setup, where you can set the
Resolution, speed and power.
REMEMBER THE STEPS:
1) Insert the item to be engraved.
2) Focus (or enable auto focus).
3) Close the door.
4) Confirm the exhaust is on.
5) Press GO and then "Print" from your computer.
Section 6 – Using The Epilog Legend
December, 2000
35