Rf Module - Epilog Laser Legend 6000 Owner's Manual

Owner's Manual for EPILOG Legend Model 6000
December, 2000

RF MODULE

The 50 and 100 watt laser systems use lasers with separate RF drivers. This is done for performance reasons,
to keep the heat generated by the RF away from the laser itself.
50 W at t air cool ed conf igur at ion
The RF driver for the 50 watt is located to the right of the laser, under the laser cover. To service the RF,
remove the laser cover. The cover is held in place with four or five phillips head screws. The RF is held in
place by three or four Allen head screws on the top, and three or four hex nuts on the bottom as shown in the
following diagram. You will also need to demate the power, control and RF connectors shown in the
drawing.
78 Section 15 – Servicing the Legend