Table of Contents
Advertisement
Owner's Manual for EPILOG Legend Model 6000
Problem: Engraving appears weak.
Solution:
All mirrors and lens need to be cleaned and inspected for damage. See Section 7 of the manual for
instructions. If you are unsure of the location of all of the mirrors on your engraver, please contact
Technical Support.
Verify that the lens is in correct focus.
Verify correct speed and power settings for the type of material that you are engraving.
Problem: No laser beam but the engraver appears to be running normally.
Solution:
Verify focus is set properly.
Verify power and speed settings are appropriate.
Problem: Scanned images will not print or will not print correctly.
Solution:
If you are using Corel 3.0 or 5.0, do not rotate your image. Rotate the artwork before you scan it.
If you are using Corel 5.0, verify that it is version G1.
To do this click on "Help" in Corel 5.0 then click on "About
CorelDraw". If it is not revision G1, then contact Corel for the free upgrade. Be prepared to
supply Corel with your software serial number.
If you are using Corel 6.0 or 7.0, there are three settings in Corel that require the proper setting.
Put some type of design on your screen, a basic square will do. Then follow the instructions
below.
Click on:
File
"Setting".
Verify that Corel 6.0 is version .176; follow the instructions above for verification and updates.
Problem: Inadequate Exhaust.
Solution:
1)
The closer the blower is to the machine the better exhaust you will receive.
2)
If you are using flex hose, do not bundle up the excess. Stretch out the flex hose and use only what
you need.
3)
Clean your exhaust system on a regular basis including engraver and blower. Use a bottlebrush and a
vacuum on the areas where the exhaust buildup accumulates.
70
December, 2000
Print
Options
Then "Options" page
Then under "Special Settings" you will find the choice of "Options" and
1. First find the option "Bitmap Printing"
Set it to "Output Entire Bitmap"
2. Then find the option "Driver Banding"
Set it to "Send Bands to Driver"
3. Then find the option "Text Output Method"
Set it to "All Text as Graphics"
Section 14 – In Case of Difficulty
Advertisement
Table of Contents
