Getting Started; Unpacking Your Machine - Epilog Laser Legend 6000 Owner's Manual

Owner's Manual for EPILOG Legend Model 6000
You will need to do the following to use your machine:
1) Remove it from the crate
2) Connect your computer
3) Connect the exhaust system
4)
Connect power
5)
Configure your computer
You may need a contractor to install the exhaust (all models) and the 208-240 volts (100 watt lasers only).
This must be done PRIOR to the arrival of the Epilog installation technician.

UNPACKING YOUR MACHINE

1) Cut and remove the strapping around the box and the plywood top. Remove the plywood top.
2) Cut the tape on the top of the box. Open the flaps and remove as much packing as you can. Please
save this packing material. This includes the foam top supports and four wood and foam corner
supports.
3) Remove eight (8) Phillips head screws (w/ large washers) located around the base of the corrugated
box.
4) With a friend, lift the box up over the machine. PLEASE do not throw away the box, you may need it
later. Remove the plastic bag over the machine.
5) On the pallet (the wooden platform the machine is sitting on) locate the edge that is secured with two
screws. Loosen and remove the screws, and remove the wooden 2"x2".
6) Under the machine (all the way under), locate the ramps. They will be wrapped in plastic. Remove
them and place the metal hooks into the slots on the pallet. These ramps will allow you to roll the
machine off the pallet. There is a left and a right ramp. The raised edges must be on the outside, not
facing each other.
7) Locate the four wooden blocks supporting the machine on the pallet. These blocks need to be pulled
out. CAUTION is urged. These machines can weigh in excess of 400 lbs. With a friend or two, lift
one side of the machine just high enough to remove two of the blocks. Do the same with the other
side to remove the remaining two blocks.
8) With a friend helping, carefully roll the machine off the pallet and down the ramps. You may need to
unlock the front casters before the machine will roll freely.
9) Locate the accessory kit in the open compartment at the bottom front of the engraver. Remove this
box.
10) Open the main door to the engraver. Inside the cabinet, locate and remove two 5/8" diameter RED
shipping locks. They are toward the front of the machine and on either side of the X carriage. Turn
Section 1 – Getting Started
December, 2000

1) GETTING STARTED

1