Epilog Laser Legend 6000 Owner's Manual page 89

Owner's Manual for EPILOG Legend Model 6000
December, 2000
or some other problem disconnects the computer from the Legend during the file sending operation, it can be
re-tried, once the problem is corrected. If there is a sending problem, there will be an error indicator on the
Legend front panel saying: "Programming Receive Failure, please retry". If this is observed, reboot both
the host computer (PC) and the Legend and try again. Once the file has been completely received by the
Legend, it will begin the act of re-programming itself with the upgrade version of its firmware.
The front panel will say: "Programming Machine DO NOT DISTURB"
DO NOT POWER DOWN THE LEGEND DURING THIS TIME. If you lose power, or purposefully power
down the Legend during this time, your controller board in the Legend will be ruined, and will have to be
replaced. This operation will take about 90 seconds.
After programming is complete this message will appear: "Programming Complete, please reboot"
You may re-boot at this time and you will then have the new version of the Legend firmware installed in your
Legend. There is a README file supplied with the Legend firmware update in the self-extracting archive.
Please read it to get the latest information on Legend features and upgrades.
Section 16 – Upgrading the Operational Firmware 85