Assembling The Unit - Stihl PC 70 Instruction Manual

Assembling the Unit

Pull the protective cap off the end of
N
the drive tube and keep it in a safe
place for later use – see "Storing the
Power Tool".
Preparations
1
Place the powerhead on the ground
N
so that it rests securely on the
machine support (1). Position the
end of the drive tube (2) horizontally
or rest it on a raised support.
PC 70, PC 75
Mounting the Gearbox
Loosen the clamp screws (1) on the
N
gearbox – do not remove them.
2
Push the gearbox (2) onto the drive
N
2
tube (3) – turn it back and forth at
the same time until the end of the
drive tube is no longer visible in the
slot (arrow) – then push fully home
as far as stop.
1
Line up the gearbox on the drive
N
3
tube so that the machine support on
the engine faces down and the
gearbox cover (4) away from the
user – the gearbox cover and
muffler (5) must face in the same
direction.
NOTICE
Over-tightening can damage the drive
tube.
English
5
4
47