Stihl PC 70 Instruction Manual page 50

English
Tighten down the clamp screws by
N
hand only using the combination
wrench or to 8 Nm with a torque
wrench.
Mounting the Cutting Attachment
The palm cutter comes with the screws
and nuts required to mount the cutting
attachment.
WARNING
Sharp cutting attachment can cause
injuries. Wear protective gloves.
Different machine versions
A
B
The cutting attachment mounting
procedure differs according to the
machine version.
48
Version A
5
2
3
4
5
2
3
WARNING
The cutting attachment may drop and
cause injuries.
Use the machine only with a properly
mounted guide (3) that is in good
condition.
Fit the cutting attachment (1) in the
N
forkhead (2) and line it up with the
holes in the forkhead (2) and
guide (3). The tip of the sickle or the
chisel's hook must face the ground.
Insert the screws (4) through the
N
holes in the forkhead, cutting
attachment and guide.
Fit nuts (5) on the screws and use
N
combination wrench to tighten them
down firmly.
Version B
4
4
4
Fit the cutting attachment (1) in the
N
forkhead (2) and line it up with the
holes in the forkhead (2). The tip of
the sickle or the chisel's hook must
face the ground.
Insert the screws (3) through the
N
holes in the forkhead and cutting
attachment.
Fit nuts (4) on the screws and use
N
combination wrench to tighten them
down firmly.
Mounting the Guard
Guard kit helps protect the powerhead
when it is put down.
3
2
3
2
PC 70, PC 75