Specifications - Stihl PC 70 Instruction Manual

English

Specifications

Engine
Single cylinder two-stroke engine
Displacement: 25.4 cc
Bore: 34 mm
Stroke: 28 mm
Engine power to 0.95 kW
ISO 8893: (1.3 bhp) at
8,500 rpm
Cut-off speed: 10,500 rpm
Idle speed: 2,800 rpm
Stroke rate: 2,600/min
Ignition System
Electronic magneto ignition
Spark plug (resistor
type): NGK BPMR 7 A
Electrode gap: 0.5 mm
Fuel System
All position diaphragm carburetor with
integral fuel pump
Fuel tank capacity: 440 cc (0.44 l)
Weight
dry, with cutting attachment
PC 70:
PC 75:
66
Noise and Vibration Data
Noise data are measured at idling and
maximum rated speed in a ratio of 2:1.
Vibration data are measured off load
and at full load in a ratio of 2:1.
For further details on compliance with
Vibration Directive 2002/44/EC visit
www.stihl.com/vib.
Sound pressure level L
PC 70:
PC 75:
Sound power level L
PC 70:
PC 75:
Vibration level a
PC 70 with sickle
Drive tube (shaft):
Control handle:
PC 70 with chisel
Drive tube (shaft):
Control handle:
PC 75 with sickle
Shaft compressed:
Control handle:
Shaft extended:
Control handle:
PC 75 with chisel
Shaft compressed:
6.2 kg
Control handle:
8.4 kg
The K-factor in accordance with
Directive 2006/42/EC is 2.0 dB(A) for
the sound pressure level and sound
to ISO 11201
p
92 dB(A)
92 dB(A)
to ISO 3744
w
105 dB(A)
105 dB(A)
to ISO 20643
hv,eq
2
15 m/s
2
15 m/s
2
13 m/s
2
13 m/s
2
12 m/s
2
12 m/s
2
14 m/s
2
17 m/s
2
12 m/s
2
12 m/s
power level; the K-factor in accordance
with Directive 2006/42/EC is 2.0 m/s
for the vibration level.
REACH
REACH is an EC regulation and stands
for the Registration, Evaluation,
Authorisation and Restriction of
Chemical substances.
For information on compliance with the
REACH regulation (EC) No. 1907/2006
see www.stihl.com/reach.
Exhaust Emissions
The CO value measured in the EU type
2
approval procedure is specified at
www.stihl.com/co2.
The measured CO value was
2
determined on a representative engine
in accordance with a standardized test
procedure under laboratory conditions
and does not represent either an explicit
or implied guarantee of the performance
of a specific engine.
The applicable exhaust emission
requirements are fulfilled by the
intended usage and maintenance
described in this instruction manual. The
type approval expires if the engine is
modified in any way.
PC 70, PC 75
2