Table of Contents
Advertisement
Using the Unit
2
Preparations
The special harvester may only be
operated with the harness attached.
:
Start the engine – see "Starting/
Stopping the Engine".
:
Put on the harness – see "Fitting the
Harness".
:
Attach the hook (1) to a branch. Use
the handle hose (2) on the drive
tube to turn the hook to the required
position.
SP 200
1
Working Position
:
Use the harness (3) to put the hook
under tension while holding the
control handle loosely with your
right hand. The left hand remains
free.
:
With the hook under tension, open
the throttle and begin the shaking
process.
3
English / USA
Assembling the Unit
2
1
2
6
5
4
Mounting Front End of Drive Tube
This chapter describes only the
procedure for first time mounting –
for subsequent mounting procedure
see chapter on "Transporting the
Machine".
:
Remove the protective caps (1)
from the ends of the drive tube (2)
and keep them in a safe place.
:
Push the front end of the drive tube,
thread first (3), onto the splined
shaft (4) an then onto the taper (5)
until the nut (6) engages the thread.
1
3
13
Advertisement
Table of Contents
