Approved Power Tool Attachments; Assembling The Unit - Stihl HL 94 Instruction Manual

English
Swing the cutter bar in an arc towards the out‐
side of the hedge so that the cuttings are swept
to the ground.
Recommendation: Only cut hedges that are no
more than chest height.
4 Approved Power Tool
Attachments
The following STIHL attachments may be moun‐
ted to the basic power tool:
Attachment
1)
HL 0°, 500 mm
1)
HL 0°, 600 mm
1)
HL 145°, 500 mm
1)
HL 145°, 600 mm
2)
HT
2) 3)
BF
SP 10
1)
Loop handle required on versions with long drive tube (HL 92, HL 94)
2)
Not approved for versions with short drive tube (HL 92 K)
3)
Loop handle required
10
Application
Long reach hedge trim‐
mer
Long reach hedge trim‐
mer
Long reach hedge trim‐
mer
Long reach hedge trim‐
mer
Pole pruner
Cultivator with pick tines
Special harvester

4 Approved Power Tool Attachments

5

Assembling the Unit

5.1 Mounting the Loop Handle
(HL 92, HL 94)
Loop handle is required on versions with long
drive tube (HL 92, HL 94).
3
► Place the clamp (1) in the loop handle (2) and
position them both against the drive tube (5)
between the carrying ring (3) and handle
hose (4).
► Position the clamp (6) against the shaft.
► Line up the holes.
► Insert the screws (7) with washers (8).
► Fit the square nuts (9) and screws.
7
7
8
8
2
1
5
6
9
9
0458-519-8321-D
4