Supporting floor
h
P_MOZ_0016_SW
Fig. 7
Fig. 6: Correct heigh of the clutch claw on the motor shaft
Size
Motor flange
143 / 145TC
100
B5 / 250
WARNING!
Danger of electric shock
If water or other electrically conducting liquids penetrate into
the drive housing, in any other manner than via the pump's
suction connection, an electric shock may occur.
–
Position the pump so that it cannot be flooded.
WARNING!
The pump can break through the base or slide off it
–
Ensure that the base is horizontal, smooth and perma‐
nently load-bearing.
Dosing rate too low
Vibrations can disrupt the liquid end valves.
The supporting floor must not vibrate.
–
Assembly
P_HY_0060_SW
Q
2-1/8"
53.975
60
19