Attaching The Waste Container; Emptying The Waste Container - Kärcher MC 250 Manual

Mounting the locking buttons (4x)
The locking buttons 6.321-295.0 are part of the "Supports"
attachment kit
Locking button
1
Counternut
2
Waste container frame for inserting the support
3
● Screw the locking button into the thread of the welded
nut on the frame and adjust:
a If the setting is correct, the bolt of the pulled locking
button releases the slot for the supports.
b Secure with counternut.

2.0.1 Attaching the waste container

DANGER
Risk of injury from the waste container
Keep a sufficient distance from the waste container and
the supports when removing/installing.
Maintain a sufficient clearance to the hazard zone and stop
raising/lowering of the waste container immediately when
a person enters the hazard zone.
Secure the raised waste container with the safety supports
when you work underneath.
ATTENTION
Risk of injury and damage
Set the waste container down only on a level and smooth
surface.
Check the correct seating of ball sockets and locking pins
when installing.
If necessary, use the assistance of a second person
(guide) when attaching the waste container.
Figure: Waste container on supports
Waste container
1
Rear supports (2x)
2
Left front support
3
30
Right front support
4
The waste container is attached to the vehicle in the re-
verse order to removal, which is why the pictorial rep-
resentation is omitted here.
1. Drive the vehicle carefully under the waste container.
a The side panels on the left and right must be open.
2. Lower the waste container by cranking the supports until
the waste container lies securely in the 4 ball sockets.
Use the assistance of a second person if necessary.
Side cover
1
Support
2
Locking button
3
Crank
4
3. Pull the locking button and release the lock of the sup-
ports, pull out the supports (4x).
4. Insert the rear locking pins (left and right) and secure
with spring pins.
5. Depressurise the rear hydraulic system, see chapter
"Hydraulic pressure relief".
6. Connect the hydraulic hoses of the waste container
(note the colours).
7. Connect the power supply plug.
8. With optional high-pressure cleaner: Connect the water
connection.
9. Raise the waste container and secure it with the safety
supports.
10.Fit the sealing collar.
11.Insert the front locking pins (left and right) and secure
with spring pins.
12.Lower the waste container completely. Fold in the safe-
ty supports beforehand.
13.The waste container is now attached to the vehicle.
14.Select the appropriate > Sweep < program on the dis-
play.

2.0.2 Emptying the waste container

CAUTION
Risk of tilting
Only empty the waste container on a firm even subsurface.
Maintain the safety distance while emptying on dumps or
ramps.
CAUTION
Danger due to rolling away
Set the travel direction lever to neutral for emptying.
Apply parking brake.
CAUTION
Danger of injury
Switch off the suction fan before emptying the waste con-
tainer.
English