Storage; Sweeping Mode; Symbols On The Display When Sweeping; Intersection Function - Kärcher MC 250 Manual

Implements
Hide thumbs Also See for MC 250:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 27
Adjusting the head inclination forwards
Lock nut
1
Hexagon
2
5. Unscrew the counternut.
6. Adjusting the head inclination via the hexagon.
7. Tighten the counternut.
Adjusting the brush contact pressure
8. The brush system has a hydraulic brush contact pres-
sure adjustment system.

2.3.10Storage

WARNING
Risk of injury and damage
Note the weight of the device.
ATTENTION
Risk of damage
Store the attachment kit in a protected, level and dry place.
Ensure that the sweeping brushes are not loaded.
1. Store the sweeping system that has been removed from
the vehicle on the changing carriage.
2. Ensure that the sweeping brushes are not loaded during
attachment to the vehicle.
2.4

Sweeping mode

2.4.1 Symbols on the display when sweeping

The following additional symbols and warning indicators
may be shown on the display when sweeping.
Suction mouth is down (lowered)
Suction mouth camera activated
Recycling water level low
Waste container/platform cannot be operated
Waste container is raised
Intersection function active
40

2.4.2 Intersection function

The vehicle has an intersection function. This allows the
broom system and the suction mouth to be raised and the
rotation of the brushes and the water supply switched off
at the push of a button. Everything can then be reactivated
after this.
Travel direction selector switch
1
1. Press the travel direction selector switch to the end po-
sition.
a The intersection function is activated and an indicator
lights up in the display.
2. Press the travel direction selection switch again.
a The intersection function is deactivated and the indi-
cator in the display goes out.
b The brushes turn again, the suction mouth is lowered
and the water supply starts again.
c The cleaning work continues with the previously set
values.
2.4.3 Sound proofing attachment kit (ex-factory
option)
A sound proofing attachment kit is installed at the factory
can be recognized by an additional label 99 dB (A) on the
rear of the waste container.
Label 99dB (A)
1
English
Warning, recycling water level too low
- do not switch on the water circulation
function (recycling water)
Warning, the waste container is raised
Warning, the waste container lid is
open

Advertisement

Table of Contents
loading

Table of Contents