Kärcher MC 250 Manual page 28

Sealing collar
1
Hose clip
2
4. Remove the sealing collar by opening the hose clip (SW
7) and pulling off the sealing collar.
Figure: Variant A with 2 short locking pins
Front locking pin, short
1
Spring pin
2
Rear locking pin, short
3
Figure: Variant B with long locking pin
Locking pin, long
1
Spring pin
2
Hexagon bolt
3
5. Variant A: First pull out the spring pins and then pull out
the front short locking pins (left and right).
6. Variant B: First pull out the spring pins and then com-
pletely pull out the long locking pins (left and right).
a Use an impact extractor (slide hammer) for pulling out
b For this, unscrew the hexagon bolt and screw the
slide hammer into the existing thread.
28
7. Raise the waste container slightly and fold the safety
supports to the rear and into the storage position.
8. Lower the waste container completely.
9. Depressurise the rear hydraulic system, see chapter
"Hydraulic pressure relief".
Rear hydraulic connections
1
10.Disconnect the hydraulic hoses of the waste container
from the hydraulic connections.
Power supply plug
1
High-pressure cleaner water connection (option)
2
High-pressure cleaner (Option)
3
11.Unplug the power supply plug.
12.Disconnect the reversing camera cable (if present).
13.With optional high-pressure cleaner: Disconnect the
water connection.
14.Pivot the side covers (left and right) outwards.
Figure: Attached locking button with inserted and secured
support
Rear side cover
1
English