Oracle Acme Packet 4600 Hardware Installation And Maintenance Manual page 95

Alarm Alarm ID
PLD 65544
VOLTAGE
ALARM 2P5V
(2.5 Volt Rail)
PLD 65545
VOLTAGE
ALARM 3P3V
(3.3 Volt Rail)
PLD 65546
VOLTAGE
ALARM 5V
(5 Volt Rail)
PLD 65547
VOLTAGE
ALARM CPU
(Host Voltage)
NIU Alarms
The following table lists the NIU alarms. PHY0 and PHY1 are both located on the
same NIU. PHY0 encompasses S0P0 and S0P1, while PHY1 encompasses S1P0 and
S1P1. Therefore, both insertion and both removal alarms will be activated at the same
time when the NIU is inserted or removed from the Acme Packet 4600.
Alarm Alarm ID
PHY0 Removed 65550
PHY0 Inserted 65552
Alarm Cause(s)
Severity
MINOR A PLD
exceeds a
EMERGENCY
predetermined
threshold
MINOR A PLD
exceeds a
EMERGENCY
predetermined
threshold
MINOR A PLD
exceeds a
EMERGENCY
predetermined
threshold
MINOR A PLD
exceeds a
EMERGENCY
predetermined
threshold
Alarm Severity Cause(s)
MAJOR NIU S0Px was
removed
MAJOR NIU S0Px was
inserted
Chapter 6
Alarms
Log Message Graphic
Display
Window
Message
Voltage 2.5V X HW
CPU has ALARMS:
minor alarm (where X is
the number of
Voltage 2.5V
hardware
CPU has
alarms
emergency
alarm, the
system should
shut down
Voltage 3.3V X HW
has minor ALARMS:
alarm (where X is
the number of
Voltage 3.3V
hardware
has
alarms
emergency
alarm, the
system should
shut down
Voltage 5V X HW
has minor ALARMS:
alarm (where X is
the number of
Voltage 5V
hardware
has
alarms
emergency
alarm, the
system should
shut down
Voltage CPU X HW
has minor ALARMS:
alarm (where X is
the number of
Voltage CPU
hardware
has
alarms
emergency
alarm, the
system should
shut down
Log Message
Physical interface
card 0 has been
removed
None
6-36