Installing A Power Supply - Oracle Acme Packet 4600 Hardware Installation And Maintenance Manual

from the Acme Packet 4600 chassis:
Remove the power cables from the power
1.
supplies.
With your thumb, push the grey locking tab to the left to unlock the power supply
2.
from the chassis.
Holding the handle, pull the power supply towards you. This will disengage the
3.
power supply from the midplane and the chassis.
Continue pulling the power supply towards you until it is completely out of the
4.
chassis.
Move the power supply to an ESD-safe location.
5.
Ground yourself with an ESD wrist strap before installing a power supply.
6.

Installing a Power Supply

To install a power supply in the Acme Packet 4600 chassis:
Locate the power supply to be installed.
1.
Locate the empty power supply slot in the chassis.
2.
Note:
NEVER power up a power supply before it is installed in the Acme
Packet 4600 chassis.
Power Supply Removal and Replacement
To remove a power supply
Chapter 6
6-9