Install The Rcm - Sprayer Cables And System Power Cables - Raven Hawkeye 2 Installation Manual

CHAPTER 5

INSTALL THE RCM - SPRAYER CABLES AND SYSTEM POWER CABLES

1. Locate the RCM - Sprayer adapter cable (P/N 115-2005-095) provided in the kit.
2. Identify the two RCM - Sprayer connectors (one black, one gray) and connect these to the RCM - Sprayer.
FIGURE 4. RCM - Sprayer Connections
3. For model years 2019 & 2020, identify the four 12-pin Deutsch connectors (one of each: gray, black, green,
brown) grouped together and connect them to the matching disconnected PCII cable connections.
NOTE: For model years 2017 & 2018, the four 12-pin Deutsch connectors will be connected in a later step.
4. Locate the RCM - Sprayer breakout cable (P/N 115-2005-001 or 115-2005-091) provided in the kit.
5. Connect the 23-pin connector (black) of the breakout cable to the remaining connector (also black) of the RCM
- Sprayer.
6. Route the breakout cable down the center rack to the center boom section break as shown in Figure 5, "Left/
Right Inner Cable Breakout," following existing cabling and hose plumbing where possible.
7. Connect the large, round female receptacles to the mating connectors on the left and right inner boom cables
previously installed as shown in Figure 5, "Left/Right Inner Cable Breakout," below.
FIGURE 5. Left/Right Inner Cable Breakout
8. Secure the power modules on the breakout cable to existing cables and plumbing.
NOTE: Secure the RCM - Sprayer cables to nearby existing cables with zip ties, ensuring not to pull on any
connections and prevent any cable loops from drooping below chassis.
34 Hawkeye® 2 Installation Manual for ET Apache Sprayers MY 2017+