System Power Connection (My 2019 & 2020) - Raven Hawkeye 2 Installation Manual

SYSTEM POWER CONNECTION (MY 2019 & 2020)
1. Locate the black 8-pin connector on the RCM - Sprayer breakout cable (P/N 115-2005-091).
2. Locate the black receptacle on the power module box near where the RCM - Sprayer was installed.
FIGURE 13. ET Apache Center Rack Power Module
3. Connect the breakout cable black, power connector to the matching connector on the power module box.
4. Locate the ring terminal on the RCM - Sprayer breakout cable.
5. Locate the ground terminal on the back side of the mounting plate behind the power module.
FIGURE 14. ET Apache Center Rack Ground Connection
6. Remove one of the ground nuts from the ground bolts.
7. Place the ring terminal on the ground bolt and secure the nut back into place.
RCM - Sprayer Mounting and Connection: Install the RCM - Sprayer Cables and System Power Cables
RCM - SPRAYER MOUNTING AND CONNECTION
39