Hitachi CE50-10 Instruction Manual page 98

5. Configuring Software Environment
(b) Operation procedure
Use the remote operation terminal to remotely log in to the unit in which the information to be backed up is stored,
and then run the backup command. Then, save the backup files in the maintenance PC by using the scp operation
terminal.
Figure 5‒20: Flow of backup steps in configuration No. 2
1. Check the communication between the maintenance PC and the unit by using the remote operation terminal.
Run the ping command to confirm that the maintenance PC can communicate with the unit.
$ ping IP-address-of-the-target-unit
2. Remotely log in to the unit from the maintenance PC by using the remote operation terminal.
Remotely log in to the unit as a user who can run the sudo command.
Example user name: edgeadm
login: edgeadm
Password: *******
3. Confirm that the OS operation mode is set to maintenance mode.
Run the showecmode command to confirm that the bold underlined parts are displayed as follows.
$ sudo showecmode
Current : Maintenance mode
Next : Maintenance mode
$
4. Run the backup command.
Run the ecbackup command to create backup files in the unit. The following example shows how to run the
ecbackup command.
82