Hitachi CE50-10 Instruction Manual page 167

Figure 8‒5: Flow of maintenance information collection in configuration No. 3
The following describes the operation procedure and command input examples. When entering a command, check the
underlined parts.
1. Log in to the unit.
Login: edgeadm
Password: *******
2. Confirm that the OS operation mode is set to maintenance mode.
Run the showecmode command and confirm that the following is displayed (check the underlined parts).
$ sudo showecmode
Current : Maintenance mode
Next : Maintenance mode
$
3. Connect the external media.
Connect the external media, and then run the usbctl command. The following example shows how to run the
command to connect the external media to USB port number 1.
$ sudo usbctl -p 1 -c
4. Run the batch collection command.
Run the eclogsave command to save maintenance information in the external media. The following shows an
example in which the external media is recognized as /dev/sdb and batch collected information is stored
in /dev/sdb1.
$ sudo eclogsave /dev/sdb1
### Started a save of system information. ###
20150801181021-eclog/1_RAS_LOG/raslog.tgz completed.
20150801181021-eclog/2_MEM_DUMP/20150718212439.tgz completed.
20150801181021-eclog/3_SDA6_LOG/sda6.dump completed.
20150801181021-eclog/4_USER_LOG/userlog.tgz completed.
20150801181021-eclog/5_MAINT_INFO/maint_info.tgz completed.
20150801181021-eclog/6_EXTPP_LOG/extpplog.tgz completed.
### Started a compression of system information. ###
### Successfully completed.(20150801181021-eclog.tgz) ##
$
5. Remove the external media.
Run the usbctl command, and then remove the external media. The following example shows how to run the
command to disconnect the external media from USB port number 1.
$ sudo usbctl -p 1 -d
6. Log out from the unit.
8. Troubleshooting
151