Hitachi CE50-10 Instruction Manual page 111

$ sudo rxversion
<Active><Running>(/dev/sda2)
CTRL-EDGEN-IMG
<Inactive>(/dev/sda3)
CTRL-EDGEN-IMG
<BIOS>
version-information
<RAS MCU F/W>
version-information
<TPM>
version-information
$
15. Log out from the unit.
$ exit
(4) Updating the OS in configuration No. 2
The following describes the procedure for updating the OS of the unit with the OS file in the maintenance PC
connected to the unit. You can perform this operation in normal mode or maintenance mode. The following describes
the operation procedure in normal mode.
(a) Preparation
• Save the OS file currently stored in the unit, to the maintenance PC.
• Stop online application operations on the unit.
• Stop the unit, and then connect it with the maintenance PC by using an Ethernet cable.
If necessary, disconnect other devices from the unit.
(b) Operation procedure
Use the maintenance PC to remotely log in to the target unit for updating the OS, and then run the OS update
command.
model-name version-information
model-name version-information
5. Configuring Software Environment
95