Hitachi CE50-10 Instruction Manual page 124

5. Configuring Software Environment
Item
(c) Backup targets: /dev/
sda8 /dev/sda9 /dev/
sda10 /media/etc
(d) Partition /dev/sda8 backup
start.
(e) 31MiB 0:00:01 [16.1MiB/s]
[====> ] 25% ETA 0:00:02
(f) Will you verify backup
files(y / N)? y
Verifying:20210525101010_s
da8_01.gz
Will you verify backup
files(y / N)? y
Verifying:
20210525101010_sda8_01.gz
(g) The file and the partition
doesn't match. Retry?(y /
N)y
Finished:20210525101010_sd
(h)
a8_01.gz: xxx,xxx,xxx
bytes
(i) Directory /media/etc
backup start.
(j) Successfully completed
3. To back up data to the maintenance PC, enter 2, and then press the Enter key.
The following screen appears.
Partition info backup started.
Partition Info backup finished.
Backup directory: /mnt/ecbackup_data/ecbackup_20210525101010
Backup targets: /dev/sda8 /dev/sda9 /dev/sda10 /media/etc
Partition /dev/sda8 backup start.
31MiB 0:00:01 [16.1MiB/s] [====>
Will you verify backup files(y / N)? y
108
Display
The partitions or directories to be backed up
The partition in which backup starts
The storage status of the backup file being created in the external
media.
The following are displayed from left to right:
• Capacity of the partition stored in the backup file
• Elapsed time
• Data transfer rate (amount of transferred data/second)
• Progress bar
• Progress rate (percentage display)
• Estimated remaining time (required for processing)
The displayed progress rate might slightly exceed 100%.
The progress bar and the progress rate indicate the following
values:
Capacity of the partition stored in the current backup file ÷
(partition size - capacity of partitions already backed up in the
backup file) x 100 (%)
If the size of the backup file exceeds 1 GB, the saving of the
backup file ends, and the progress bar and the progress rate
indicate a value lower than 100%. The data that has not been
backed up will be recorded in the next backup file.
This message asks you whether you want to verify that the backup
files are saved normally.
If you enter y, the saved backup file is compared with the target
partition or directory to confirm that they match.
If you enter N, the message in (h) appears, and then creation of the
next backup file starts.
If the verification in (f) shows that the backup file was not saved
normally, this message appears, asking you whether you want to
rerun the backup.
If you enter y, the message in (f) appears again.
This message indicates that saving of the backup file finished.
Information for (c) to (h) appears repeatedly for the partitions and
directories that have not been backed up yet.
The directory in which backup starts
This message indicates that backup of all directories indicated in
(c) finished.
Description
] 25% ETA 0:00:02
...(a)
...(a)
...(b)
...(c)
...(d)
...(e)
...(f)