Rxosenable - Hitachi CE50-10 Instruction Manual

5. Configuring Software Environment
<Diagnosis>
For the exit code, 0 is returned if the status is normal and 1 is returned if an error is detected. Table 5‒31: List of
ecosupdate command error messages below shows error messages that are output when an error is detected.
Table 5‒31: List of ecosupdate command error messages
No.
1 Usage:
/hitachi/bin/ecosupdate -h
/hitachi/bin/ecosupdate <dir>
2 ecosupdate: Directory not
found.
3 ecosupdate: Extracting root
partition failed.
4 ecosupdate: OSverinfo is not
found.
5 ecosupdate: OSverinfo is
broken.
6 ecosupdate:OS update file is
not found or broken.
7 ecosupdate: Failed to save /
hitachi/etc/ecosupdate/
system<1|2>/boot.tgz
8 ecosupdate: Failed to save
root partition to /dev/sda<2|
3>.
9 Backup for boot partition
failed.
10 ecosupdate: ecosupdate needs
root privilege. Try 'sudo
ecosupdate'.
11 ecosupdate: OS update failed.
Please re-try.
12 ecosupdate: system,error. OS
update failed.
5.18.6 rxosenable
<Name>
rxosenable - Change the active OS area.
<Format>
rxosenable [-h] [-p | -s | -e {2,3}]
<Description>
This command changes the system area to be started next.
114
Error message Description
The specified argument is invalid.
Revise the specified option, and then rerun the command.
The specified directory does not exist.
Revise the specified directory path, and then rerun the command.
An attempt to extract the OS update file to the root partition
failed.
Rerun the command.
OSverinfo was not found.
Store the file again, and then rerun the command.
OSverinfo is corrupted.
Store the file again, and then rerun the command.
osprog_base.tar was not found or is corrupted.
Store the file again, and then rerun the command.
An attempt to save the boot partition file failed.
Confirm that /hitachi/etc/ecosupdate/ is writable, and
then rerun the command.
An attempt to save the root partition failed.
Rerun the command.
An attempt to back up the boot partition failed.
Confirm that /hitachi/etc/ecosupdate/ is writable, and
then rerun the command.
Running the command requires root privileges.
Use sudo.
Processing of the ecosupdate command did not finish. The
active area of the OS has not been changed.
Eliminate the cause of the error, and then rerun the command.
Processing did not finish due to an unknown error.
Restarting the OS might cause it to be unable to start.
Eliminate the cause of the error, and then rerun the command.