Icom IC-F620 Programming Software Manual page 68

Group Row
PassPort Reacquire
Features Time
PassPort Selective Call
Features Wait Time
Other Time Loss of
Carrier Roam
Start
Other Time Select System
Roam Delay
Other Time Roaming
Wait
When done editing in this programming screen you can proceed to other programming
screens, save your programming parameters to a file or proceed to writing the
information to the radio (assuming that editing has been finished for all other required
programming screens also).
CS-F620TR Programming Software Manual
Description
Enter from 0 to 250. If a PassPort radio
goes into search (roam) mode and it
attempts to go back to the same site it left, it
will not attempt to register to the site
(because it probably does not need to)
unless this period of time has elapsed.
Enter from 10 to 30. This is the amount of
time the radio will wait for a successful
selective call to be setup by the system after
the radio initiates a selective call.
Enter from 2 to 250. This is the amount of
time between when radio has lost low speed
data from the PassPort system that it is
currently registered to and when it will go
into search (roam) mode.
Enter from 2 to 250. After a new system is
selected, this is the amount of time the radio
will wait until initiating search (roam)
mode.
Select from 2 to 65.535. If a radio is in
search (roam) mode, this is the amount of
time the radio will wait on each frequency
for PassPort data activity before moving on
to the next frequency in its neighbor lists or
seed list.
(rev 1.0) -
Default
90.000
20.000
30.000
11.000
5.500
Trunking Features Programming Screen
Suggested
Settings
90.000
30
20
7
This setting
should be set
to about 2.5
times the idle
message
interval of the
PassPort
system. For
example, if
the system is
setup to send
out an idle
message
every 2
seconds, then
the suggested
setting here
would be "5".
65