Icom IC-F620 Programming Software Manual page 51

Group Field
Timer First Digit
Timer Special
Digit
Timer Digit time
Timer Inter Digit
When done editing in this programming screen you can proceed to other programming
screens, save your programming parameters to a file or proceed to writing the
information to the radio (assuming that editing has been finished for all other required
programming screens also).
CS-F620TR Programming Software Manual
Description
Enter from 0 to 32.767 (in seconds). Sets
period of time in which the first digit of the
DTMF sequence will sound. Useful to provide
extra "wakeup" time for various DTMF decode
systems.
Enter from 0 to 32.767 (in seconds). Sets
period of time in which special digits "*" (same
as "E") and "#" (same as "F") will sound.
These tones are often used as control codes and
it is sometimes useful to have special control
over their tone duration.
Enter from 0 to 32.767 (in seconds). Sets
period of time in which the each digit of the
DTMF sequence will sound (other than Special
Digit or First Digit).
Enter from 0 to .255 (in seconds). Sets period
of time between the sounding of each DTMF
digit.
(rev 1.0) -
Default
.1
.1
.1
.1
DTMF Encode Programming Screen
Suggested
Settings
Set as
needed.
Set as
needed.
Set as
needed.
Set as
needed.
48