Icom IC-F620 Programming Software Manual page 36

Group Field
Scan Auto Group
Select
Scan User Edit
Scan Save User
Settings
Scan Edit TG
List
Scan Save TG
Scan
DTMF Decode ch
CS-F620TR Programming Software Manual
Description
Select "Enable" or "Disable". Selecting
"Enable" here puts the radio automatically into
group scan as this system is selected. The
groups scanned will be the groups set to "Yes"
in the Scan Member field of the LTR Talk
Group Setting programming sub-screen (see
page 36). Even if this field is enabled, Scan can
be toggled between "Disable" and "Enable" if
the Scan key is pressed (assuming the Edit TG
List field is set to "Enabled"). Note: if Block
Mode is "Enabled" then the type of scan used
(if this field is enabled) will be "Block".
Otherwise, it will be "Individual".
Select "Enable" or "Disable". Allows user to
manually add or delete this system from the list
of systems to be scanned. These edits are
normally lost if the user changes groups or
cycles power to the radio (though not when
changing groups) unless the Save User Settings
field is enabled.
Select "Enable" or "Disable". Allows user's
changes to the systems being scanned to be
saved when the radio's power is cycled or the
system is changed.
Select "Enable" or "Disable". Allows user to
manually edit the groups being scanned. These
edits are normally lost if the user changes
groups or cycles power to the radio (though not
when changing groups) unless the Save TG
Scan field is enabled.
Select "Enable" or "Disable". Allows user's
changes to the groups being scanned to be
saved when the radio's power is cycled or the
system is changed.
Select "None" or any of the "DTMF Decode
Pri-Codes" listed. If a "DTMF Decode Pri-
Code" has been selected, the radio will emit a
ring tone and flash a "bell" icon if the proper
DTMF sequence of digits is received. You
must set up a DTMF decode entry to use this
function (see the DTMF Decode programming
screen - page 48). If the Select Call key is
pressed, the radio will also mute to dispatch
traffic until DTMF digits matching the Primary
Code or Secondary Code digit string for the
selected DTMF entry has been received.
Default
Disable
(Blank)
Disable
(Blank)
Disable
(Blank)
Disable
(Blank)
Disable
(Blank)
None
(Blank)
LTR Programming Screen
(rev 1.0) -
Suggested
Settings
Set as
needed.
Set as
needed.
Set as
needed.
Set as
needed.
Set as
needed.
Set as
needed.
33