Timers Programming Screen; Timers Programming Screen Field Description Table - Icom IC-F620 Programming Software Manual

TIMERS PROGRAMMING SCREEN

T P
IMERS ROGRAMMING
programming screen allows the programmer to edit all global timing parameters.
The preceding screen shot shows the defaults for this programming screen. Double click
on the field you wish to edit. The next table is a description for each row in each group:
T
IMERS
Group Row
Scan Delay Resume
Timers Delay
Scan Delay Group Revert
Timers
Scan Delay CTCSS Scan
Timers Delay
CS-F620TR Programming Software Manual
S I : Located in Common folder. This
CREEN CON
P S
ROGRAMMING CREEN
Description
Enter from .1 to 25.5 seconds. When scan stops on a busy
channel and then the channel activity goes away, this is
the interval of time between when the activity goes away
and scan resumes.
Enter from 0 to 10 seconds. If the radio in group scan
stops on an active group, this is the interval of time
between when the activity goes away and the radio
reverts back to the currently selected group (for transmit
purposes). In other words this is the amount of time you
have to reply back to a scanned group. If the user does
not press the PTT in this interval of time after activity on
the scanned group has ceased, the transmission will come
up on the current group and not the scanned group.
Enter from .2 to 5 seconds. This is the interval of time
that the radio will stay on the channel during scan to
decode a CTCSS tone. If it cannot decode the proper tone
in this interval of time, scan will continue.
F D
IELD ESCRIPTION
Timers Programming Screen
(rev 1.0) -
T
ABLE
Default
2.000
5.000
0.300
62