Icom IC-F620 Programming Software Manual page 53

Group Field
Dead Beat Disable
Code
Dead Beat Response
Idle Reset
When done editing in this programming screen you can proceed to other programming
screens, save your programming parameters to a file or proceed to writing the
information to the radio (assuming that editing has been finished for all other required
programming screens also).
CS-F620TR Programming Software Manual
Description
Enter up to 10 numbers here. This is the
sequence of DTMF digitals that will "stun" the
radio, causing it to become mute and unable to
transmit. Use the value in the Dead Beat Enable
Code field to reactivate the radio to normal.
Cycling the power or changing systems will not
clear the radio from "stun" mode. The radio
will display the text in the Stun Text field of
the Field Data programming screen on power
up if it is in "stun" mode.
Select "None" or any listed entry (you must
have entries in the DTMF Encode
programming screen to see a list of selections
here). This is the DTMF response given upon
the proper decode of the digits in the Dead Beat
Disable Code field.
Enter from .1 to 32.767 (in seconds). Time
receiver is un-muted after decode.
(rev 1.0) -
Default
Blank
None
5.000
DTMF Decode Programming Screen
Suggested
Settings
Set as
needed.
Set as
needed.
Set as
needed.
50