Electrical Installation: Three-Phase Motors; Connect The Electrical Supply To The Motor; Motor Voltage Selection: Single-Phase Motors, 110/200-240 V 50 Hz And 115-120/200-240 V 60 Hz - Edwards E2M28 Instruction Manual

A373-10-880 Issue T
Figure 7 - Motor voltage selection: single-phase motors, 110/200-240 V 50 Hz and 115-120/200-240 V 60 Hz
A. Top view of motor
B. Internal view of top of motor
C. On/off switch
3.7

Electrical installation: three-phase motors

3.7.1

Connect the electrical supply to the motor

Ensure that the electrical installation of the pump conforms with local and national safety
requirements. It must be connected to a suitably fused and protected electrical supply and a
suitable earth (ground) point.
Ensure that the motor is correctly configured for the electrical supply voltage and frequency. If not, the motor
can be damaged.
Note: The pump will restart automatically when the electrical supply is restored after an interruption. If
automatic pump restart is not desired, use electrical control equipment which must be reset manually.
Page 16
1. Terminal box cover
2. Electrical inlet socket
3. On/Off switch
4. Position 'I' (on)
5. Position 'O' (off)
6. Voltage selector switch
7. Position 'II' (high voltage setting 200 – 240 V)
8. Position 'I' (low voltage setting 110 – 120 V)
WARNING
CAUTION
© Edwards Limited 2014. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.