Operation Using Remote On/Off Switch - Sensata dimensions 12NP18 Owner's Manual

Operation Using Remote "On/Off " Switch
The inverter is ready to turn on once the inverter and remote "On/Off " switch has been fully installed, wired, and
DC power has been applied. The status LED on the right side of the inverter shows the status information of the
inverter and charger.
Inverter Power Mode (Using Remote "On/Off " Switch)
Turning the Inverter "On" or "Off " (no AC applied)
The inverter can now be turned on by turning on the remote switch. When the inverter is on, the status LED will
blink amber.
Turning the Inverter "On/Off " remotely via CAN commands.
RV-C CAN commands may be used to remotely enable and disable the inverter. For CAN to work, the remote
switch must be in the "on" position. The remote switch is required to enable the inverter's housekeeping power
supply, which allows it to receive CAN commands. Contact the factory for additional information.
External Power Mode (Using Remote "On/Off " Switch)
Bypass Relay
The loads attached to the inverter output will operate directly from the external AC power line independently of
the inverter on/off status. If the inverter is left on (standby mode), the built-in bypass relay will automatically cycle
back and forth between "Inverter Power" and "External Power" mode depending on the availability of the external
AC power line.
Battery Charger
The battery charger will engage automatically and independently of the inverter on/off status. The 3-step charging
process modes are: bulk, accept, and float. The status LED will state which mode the charger is in when shore
power is applied.
Page 27
12NP Manual