Table of Contents
Advertisement
Appendix A – Remotes & Optional Equipment
Appendix A – Remotes and Optional Equipment
A-1
Remote Controls
There are several remotes that enable you to monitor and switch the inverter
on/off from a convenient location. The remotes connect to the REMOTE port
located on the front side of the MM Series inverter (see Figure 1-3, Item 10).
Depending on your inverter model, you can select one of the following remotes:
•
MM-R – Provides three LED indicators for identifying inverter status, and
includes a remote ON/OFF switch (with 25' cable). This remote is for the
MM612 model inverter (without the battery charger feature).
•
MM-RC – Provides six LED indicators for identifying inverter and charger
status, and includes a remote ON/OFF switch (with 25' cable). This
remote is for the MM1212/MM1212-G model inverters with the battery
charger feature.
•
ME-RC50 – Full feature remote with backlit LCD display and LED indicators
for identifying inverter and charger status. Provides full menu access for
easy selection and adjustment (comes with 50' cable). The ME-RC50 is
used for many inverter models and has additional features that are not
functional with the MM Series inverter. However, it can be used with all
MM Series inverter models.
A-2
Optional Equipment and Accessories
The following Magnum components are available for use with MM Series
inverters. Some of these items are required—depending upon the intended
use of the inverter.
Auto Generator Start Controller
The ME-AGS-N Automatic Generator Start controller (Network version) is
designed to automatically start your generator based on low battery condition
or high temperature. It works with 12, 24, and 48-volt battery banks and
includes a 4-position DIP (Dual In-line Package) switch which provides the
ability to change the relay timing confi gurations to allow compatibility with a
wider range of generators.
Battery Monitor Kit
The ME-BMK Battery Monitor Kit is a single battery bank amp-hour meter
that monitors the condition of the battery and provides information to let you
know how much energy you have available and to plan your electrical usage to
ensure the battery is not being over-discharged. The ME-BMK-NS version does
not include a DC shunt—order the ME-BMK to receive a 500A/50mv DC shunt.
Fuse Block/Fuses
The Magnum Fuse/Fuse-blocks are used to protect the battery bank, inverter,
and cables from damage caused by DC short circuits and overloads. They
include a slow-blow fuse with mounting block and protective cover. The 125
and 200-amp models use an ANL type fuse and the 300 and 400-amp models
use a Class-T fuse.
DC Load Disconnect
The MM-DCLD (DC Load Disconnect) pigtail adapter is designed to provide a
means to DISABLE the inverter function when a 12-volt DC signal is removed.
Ignition Switch Activate
The MM-ISA (Ignition Switch Activate) is a pigtail adapter is designed to
automatically ENABLE the inverter function when a 12-volt DC signal is
supplied.
29
© 2016 Sensata Technologies
Advertisement
Table of Contents
