Installation; Mount The Inverter - Sensata dimensions 12NP18 Owner's Manual

INSTALLATION

Mount the Inverter

NOTE: The inverter mounting location should provide adequate ventilation and clearance to maintain room
temperature during operation. At least ½" of clearance is required on all sides except the bottom. This includes ½"
beyond the mounting flanges and DC terminal covers.
Installation Tools
The following tools may be required for inverter installation:
• Wire Termination Crimper
• Cable-Ties
• Drill
• 9/16" Socket or Open Ended Wrench
• Phillips Screwdriver
• Tape Measure
• Wire Cutters
•
Wire Strippers
• 3/16'' Slotted Screwdriver
1. Locate a suitable, secure, vertical or horizontal mounting surface as close to the batteries as possible without
being in the same airtight compartment.
2. Mount the inverter using four ¼-20 steel bolts, flat and lock washers, and nuts. The length of the bolts should
be equal to the mounting material thickness plus ¾".
12NP Manual
Page 9