System Default Settings; Inverter Charger Model Options - Sensata dimensions 12NP18 Owner's Manual

System Default Settings

Inverters as shipped from the factory default to the settings in Table 12.
Setting
Low Battery
Branch Circuit Rating
Battery Type
** For 12NP18 model variants built before 7/1/18, the default battery type will be wet lead-acid. Consult the
revision level listed on the product label. Revision "G" for 12NP18 uses wet lead-acid. Revision "H" and later uses
AGM. The blink code upon initial startup maybe consulted as well for the current setting of the battery.
The battery type and low battery setting may be changed by CAN, 7-Seg Display, or the optional LCD remote. Only
the branch circuit rating can be changed with the 7-Seg display. The RV-C CAN ID will default to 1 and the baud
rate to 250k.

Inverter Charger Model Options

Option
A
G
G2N (Cube) Dual GFCI, inverter only (no charger or bypass relays), main breaker 20 A, no branch breaker
G2N (Large) Dual GFCI, inverter only (no charger or bypass relays), adds a second 20 A branch breaker
H
L
N
RJ45 remote jack (instead of 7-Seg display, includes plate and jack — no cable or display)
R
Table 16 System Default Settings
Hardwired output protected by GFCI. (cube only)
20 A main breaker for certain cube's (replaces 30 A main), no branch breaker
No GFCI or branch breaker, hardwire only
Local "On/Off " switch, non-upgradeable
Inverter-only (no charger, no bypass relays)
Order if using a LCD remote or 7-Seg display used remotely.
Table 17 Inverter Charger Model Options
12NP Manual
Default Value
10.5 VDC
15 A
AGM**
Description
Page 43