2.5.6 Removing The Display Panel; Figure 2-8, Remote Cable - Sensata Magnum Energy CSW3012-X Owner's Manual

2.0 Installation

2.5.6 Removing the Display Panel

The display panel on the inverter can be removed and installed in a different
location using a longer 6-pin standard telephony cable (also referred to as
a RJ12 cable - a 25ft cable is provided; longer cable lengths are available).
See Figure 2-8.
• Remove the 2 screws at the front of the display panel, and then
disconnect the small cable from the inverter.
• Install the remote cable in your desired location and connect one end of
the remote cable to the inverter and the other end of the cable to the
display panel. Please note polarity.
Remote cable
To locate the display panel in a remote location, the longer cable needs
to be a 6-conductor telephony type with 6P6C (6-position/6-conductor)
connectors on each end. With this cable, when the 6P6C connectors are held
side by side with both of the connector tabs facing the same way, the color
of the conductors in each connector are the opposite from top to bottom as
shown in Figure 2-8.
same
color
22
6-conductor telephony type
opposite colors top to bottom
(tabs facing toward you)
TAB
same color
TAB

Figure 2-8, Remote Cable

© 2021 Sensata Technologies