Features And Benefi Ts; Figure 1-1, Power Switch, Status Led, And Accessory Connection Ports - Sensata Magnum Energy MS Series Owner's Manual

Introduction
1.3 Features and Benefi ts
The MS Series inverter/charger is designed to allow easy access to wiring, circuit breakers, and
controls. Its die cast baseplate with one-piece aluminum cover ensures maximum durability with
minimum weight, as well as a cooler, more effi cient operation.
Note: While not pictured, the MS2000 models have the same features as those listed in this section.
The MS inverter is equipped with the following features (refer to Figures 1-1 and 1-2):
Power ON/OFF Switch – a momentary pushbutton switch that alternately turns the
1
inverter on or off .
Charging/Inverting LED Indicator – this green LED illuminates to provide status
2
information on inverter or charger operation.
Accessories Connection Port (red label) – a RJ11 port that accepts the optional RSAs
3
(Remote Switch Adapters) for remote on/off switch operation. Stacking is not supported
on these models.
Network Connection Port (green label) – a RJ11 port that accepts optional network
4
capable accessories (i.e., Auto Gen Start or Battery Monitor).
Remote Connection Port (blue label) – a RJ11 port that allows an optional remote
5
control to be connected.
Battery Temperature Sensor Connection Port (yellow label) – a RJ11 port that
6
accepts the remote Battery Temperature Sensor (BTS).

Figure 1-1, Power Switch, Status LED, and Accessory Connection Ports

Page 3
Power ON/OFF Switch
Charging/Inverting LED
(status)
Accessories Port
(red label – RJ11 connection)
Network Port
(green label – RJ11 connection)
Remote Port
(blue label – RJ11 connection)
Battery Temp Sensor Port
(yellow label – RJ11 connection)
© 2016 Sensata Technologies