Fitting The Cutting Unit - Husqvarna Rider 15V2 Operator's Manual

Fitting the cutting unit

WARNING!
Wear protective glasses when
fitting the cutting unit. The collet
spring which tensions up the belt
can go off and cause personal
injury.
1. Place the Rider on a flat surface and apply the
parking brake. Check that the lever for setting
the cutting height is in the lowest position.
Make sure the support wheels are fitted to the
cutting unit (1).
2. Grasp the handle at the front or hold the frame
of the cutting unit (2) and slide the unit
underneath the rider mower.
Make sure that the tongue (3) on the cutting unit
engages correctly.
3. Insert the bolt and secure it with a locking pin.
WARNING!
Observe caution to avoid trapping
your hand.
4. Press down the frame and insert the pin. Fit the
drive belt around the drive wheels of the cutting
unit.
5. Hook up the height adjustment strut.
34
– English
MAINTENANCE
3
1
2