A-Neuvideo ANI-8X2MFS Instruction Manual page 35

A NEUVIDEO
Serial and Telnet Commands
COMMAND
GET OUT A HUE 8
SET OUT A SHARPNESS N1 8
GET OUT A SHARPNESS 8
SET OUT A NR N1 8
GET OUT A NR 8
SET OUT A ASPECT RATIO N1 8
GET OUT A ASPECT RATIO 8
GET OUT ASPECT RATIO LIST 8
SET OUT A AUTO SYNC OFF N1 8
GET OUT A AUTO SYNC OFF 8
SET OUT A R GAIN N1 8
GET OUT A R GAIN 8
SET OUT A G GAIN N1 8
GET OUT A G GAIN 8
SET OUT A B GAIN N1 8
GET OUT A B GAIN 8
SET OUT A R OFFSET N1 8
GET OUT A R OFFSET 8
SET OUT A G OFFSET N1 8
GET OUT A G OFFSET 8
SET OUT A B OFFSET N1 8
GET OUT A B OFFSET 8
SET IN 8 PHASE N1 8
DESCRIPTION AND PARAMETERS
Show the hue value when the output is scaled.
Set the scaled output's sharpness level.
N1 = 0~63 [Sharpness level]
Show the sharpness level when the output is scaled.
Set the amount of noise reduction to apply when the output is scaled.
Available values for N1:
0 [Off]
1 [Low]
Show the current amount of noise reduction applied when the output is scaled.
Set the aspect ratio of the video shown when the output is scaled.
Available values for N1:
1 [Overscan]
2 [Full]
3 [Best fit]
4 [Pan & scan]
Show the currently set aspect ratio for the video shown when the output is scaled.
List all available aspect ratio options.
Enable or disable the Auto Sync Off function and set the timeout length.
Available values for N1:
0 [Disabled]
1 [30 seconds]
2 [60 seconds]
Show the current Auto Sync Off setting.
Set the scaled output's red gain level.
N1 = 0~1023 [Red gain level]
Show the scaled output's current red gain level.
Set the scaled output's green gain level.
N1 = 0~1023
[Green gain level]
Show the scaled output's current green gain level.
Set the scaled output's blue gain level.
N1 = 0~1023
[Blue gain level]
Show the scaled output's current blue gain level.
Set the scaled output's red offset.
N1 = 0~1023 [Red offset]
Show the scaled output's current red offset.
Set the scaled output's green offset.
N1 = 0~1023 [Green offset]
Show the scaled output's current green offset.
Set the scaled output's blue offset.
N1 = 0~1023 [Blue offset]
Show the scaled output's current blue offset.
Set the PC phase value for the VGA input.
N1 = 0~255 [PC phase]
33
Serial & Telnet Commands
2 [Middle]
3 [High]
5 [Letterbox]
6 [Underscan 1]
7 [Underscan 2]
8 [Follow input]