A-Neuvideo ANI-8X2MFS Instruction Manual page 33

A NEUVIDEO
Serial and Telnet Commands
COMMAND
SET FACTORY DEFAULT 8
SET SYSTEM REBOOT 8
SET IP MODE STATIC 8
SET IP MODE DHCP 8
SET IP MODE N1 8
GET IP MODE 8
GET IPADDR 8
SET STATIC IPADDR N1 8
SET STATIC NETMASK N1 8
GET STATIC NETMASK 8
SET STATIC GATEWAY N1 8
GET STATIC GATEWAY 8
SET WEBGUI USERNAME N1 8
GET WEBGUI USERNAME 8
SET WEBGUI PASSWORD N1 8
GET WEBGUI PASSWORD 8
SET OUT A ROUTE N1 8
GET OUT A ROUTE 8
SET OUT AUTO MODE N1 8
GET OUT AUTO MODE 8
GET IN N1 TIMING 8
DESCRIPTION AND PARAMETERS
Reset the unit to the factory defaults.
Reboot the unit.
Set the IP address assignment mode to static.
Set the IP address assignment mode to DHCP.
Set the IP address assignment mode.
Available values for N1:
0 [Static IP Mode]
1 [DHCP Mode]
Show the current IP address assignment mode.
Show the unit's current IP address.
Set the unit's static IP address.
N1 = X.X.X.X [X = 0 ~ 255, IP address]
Set the unit's static netmask.
N1 = X.X.X.X [X = 0 ~ 255, netmask]
Show the unit's current netmask.
Set the unit's static gateway address.
N1 = X.X.X.X [X = 0 ~ 255, gateway address]
Show the unit's current gateway address.
Set the WebGUI login username.
N1 = {Name} [16 characters max]
Show the current WebGUI login username.
Set the WebGUI login password.
N1 = {Name} [16 characters max]
Show the current WebGUI login password.
Route the specified input to both outputs.
Available values for N1:
1 [USB-C input]
2 [DisplayPort input]
3 [HDMI input 1]
4 [HDMI input 2]
Show the current input routed to both outputs.
Set the auto switching behavior of the unit.
Available values for N1:
0 [Off]
1 [Auto switch]
Show the current auto switching mode of the unit.
Show the index number of the current resolution detected on the specified input.
Available values for N1:
1 [USB-C input]
2 [DisplayPort input]
3 [HDMI input 1]
4 [HDMI input 2]
31
Serial & Telnet Commands
5 [HDMI input 3]
6 [HDMI input 4]
7 [HDMI input 5]
8 [VGA input]
5 [HDMI input 3]
6 [HDMI input 4]
7 [HDMI input 5]
8 [VGA input]