A-Neuvideo ANI-8X2MFS Instruction Manual page 11

A NEUVIDEO
REAR PANEL
MIC IN PORT & 48V/OFF/5V SWITCH:
q
phantom power requirements of the connected microphone.
Note: If no phantom power is required, this switch should remain in the "Off" position to avoid potential damage to connected equipment.
ANALOG AUDIO INPUT 1~6 PORTS:
w
Note: By default, Analog Audio 1 is paired with the VGA input.
AUDIO OUT 5-PIN TERMINAL BLOCK:
e
AUDIO OUT L/R 2-PIN TERMINAL BLOCKS:
r
power is provided to each speaker.
TRIGGER IN 10-PIN TERMINAL BLOCK:
t
functionality such as window security alarms, motion detectors, door switches, etc. Each of the 8 triggers will activate an assigned unit
function when triggered.
Note: A minimum of 5V DC is required to activate a trigger.
RELAY 1~2 2-PIN TERMINAL BLOCKS:
y
such as a curtain, projection screen, or lights.
IR IN PORT: Connect to an IR Extender to receive local IR control signals and extend them to devices connected to the other end of
u
the HDBaseT™ connection. Ensure that the remote being used is within direct line-of-sight of the IR Extender.
IR OUT PORT: Connect to an IR Blaster to transmit IR signals from the other end of the HDBaseT™ connection to devices within direct
line-ofsight of the IR Blaster.
Note: IR can only be routed across a single HDBaseT™ connection at a time. The HDBaseT™ connection to use is defined within the
WebGUI or OSD menu.
RS-232 1 4-PIN TERMINAL BLOCK 1 (TOP):
i
cable to send RS-232 commands to control the unit. RS-232 2 4-pin Terminal Block (Bottom): Connect to a PC, laptop, or serial controllable
device with a 3-pin adapter cable for the extension of RS-232 signals between this unit and the designated HDBaseT™ connection.
Note: The 24 volt pins are included to provide power to a dedicated external control product and should NOT be used when connecting a
standard RS-232 device.
USB-C INPUT PORT:
o
Note: Not all devices with USB Type-C ports can support video output. Please verify that the device supports video output from the USB
Type-C port before connecting it.
DISPLAY INPUT PORT:
a
Note: For 4K sources, use of cable that supports DisplayPort 1.2 or higher is strongly recommended.
HDMI INPUT 1~5 PORTS:
s
sources are supported with the use of an HDMI to DVI adapter.
VGA INPUT PORT: Connect to VGA source equipment such as PCs or laptops.
d
HDMI OUT PORT: Connect to an HDMI TV, monitor, or amplifier for digital video and audio output.
f
Connect to a standard microphone using a 6.35mm plug. Set the switch based on the
Connect to the analog stereo output of a device such as an audio player or PC.
Connect to powered speakers or an amplifier for analog stereo audio output.
Connect to unpowered 4Ω speakers for analog stereo audio output. Up to 20W of
Connect to the Trigger Control Keypad (Optional) or any device with trigger switch
Connect to devices that can be powered and controlled via a DC 0~24V/5A relay connection
Connect directly to a PC, laptop, or other serial control device with a 3-pin adapter
Connect to USB Type-C video source equipment such as a PC or laptop.
Connect to DisplayPort source equipment such as a PC or laptop.
Connect to HDMI source equipment such as media players, game consoles, or set-top boxes. DVI
9
REAR PANEL